Parker AC30V Series, Manual

Page: 109 / 337

9-4
Setup Wizard
AC30V series Variable Speed Drive
PNO Parameter Validity Comment
0564 PMAC Motor Inertia
●
The motor’s inertia
0565 PMAC Therm Time Const
●
The motor’s thermal time constant
0478 PMAC SVC Start Cur
●
The current level during the startup procedure.
0479 PMAC SVC Start Speed
●
The speed setpoint at which the speed control is switched from an open loop mode
to a closed loop mode during the startup procedure
0464
100% Speed in RPM
● ● ●
Maximum speed in RPM.
0486
Acceleration Time
● ● ●
The time that the Drive will take to ramp the setpoint from 0.00% to 100.00% when
Ramp Type
is LINEAR.
0487
Deceleration Time
● ● ●
The time that the Drive will take to ramp the setpoint from 100.00% to 0.00% when
Ramp Type
is LINEAR.
1257
Seq Stop Method VHz
●
Selects stopping mode that the controller will use once the run command has been
removed when in Volts/Hertz control mode, (induction motor only).
0484 Seq Stop Method SVC
● ●
Selects stopping mode that the controller will use once the run command has been
removed when in Sensorless Vector control mode.
0422
VHz Shape
●
Selects the Volts to Frequency curve.
0390
Duty Selection
● ● ●
Selects the drive rating. Affects the ratio of nominal current compared with maximum
overload current.
Analog Input and Output
Configuration of the ranges for the analog inputs and outputs. Also selects the thermistor type if an IO option is fitted.
PNO Parameter Comment
Setup Input/Output? Select TRUE to configure the analog input and output ranges. Set to FALSE to skip this section
0001
Anin 01 Type Select the hardware range for analog input 1
0002
Anin 02 Type Select the hardware range for analog input 2
0003
Anout 01 Type Select the hardware range for analog output 1
0004
Anout 02 Type Select the hardware range for analog output 2
1184
Thermistor Type Only shown if an IO option is fitted. If no thermistor is fitted then select NTC to avoid a MOTOR OVERTEMP Trip