Parker AC30V Series, Manual

Page: 136 / 337

Ethernet
12-1
AC30V series Variable Speed Drive
Chapter 12:
Ethernet
Introduction
Communications to the AC30 is via an Ethernet port on the Control Module. This allows access to:
•
The PDQ (Parker Drive Quicktool - the pc programming tool see Appendix D – Programming)
•
The Modbus TCP server (see Appendix A - Modbus TCP)
•
The HTTP server (see section below)
The Ethernet port operates at 10/100 MHz, half/full duplex. Internet Protocol version 4 (IPv4) is supported. Connection is recommended via an
Ethernet switch.
Connecting to a Network
Insert the Ethernet cable as shown below:
RECOMMENDED CABLE
We recommend using CAT5e screened or CAT6 screened.
Ethernet LEDs Meaning:
Activity
Link
To remove the cable first remove the GKP and
then insert a screwdriver to release the catch on
the Ethernet clip.