18
Horizontal setting
1
As shown in the figure, hold the rotation stopper
fitting with your hand to keep it in a horizontal
position, then insert the oxygen cylinder holder into
the attachment part to set horizontally.
Insert the oxygen cylinder holder deeply while
adjusting its angle so that the boss of the holder
reaches deeply into the stopper.
2
Rotate the oxygen cylinder holder as shown in the
figure and let the rotation stopper fitting go so that
the stopper works.
3
Insert an oxygen cylinder deeply into the oxygen
cylinder holder and then firmly lock the cylinder by
tightening the two thumb screw knobs (two thumb
screw knobs for locking a cylinder).
WARNING
z
z
Pay attention not to hit the
oxygen cylinder holder and
flowmeter against the bed
or wall when transporting or
adjusting the height of stretcher.
Otherwise, the oxygen cylinder
holder and flowmeter may be
deformed, resulting in injury.
Rotation
stopper fitting
Stopper
Attachment part
for horizontal
setting
Boss
Thumb screw knob (for locking a cylinder)
Attachment part for
horizontal setting
Stopper
Boss
Thumb screw knob
(for locking a cylinder)
Oxygen cylinder holder
10cm to 11.5cm diameter
Oxygen cylinder
WARNING
z
z
After mounting the oxygen cylinder holder in the horizontal
position, confirm that the stopper is working properly by shaking
the holder. If the holder is not mounted properly, an oxygen
cylinder may drop, resulting in an injury or damage.
z
z
After inserting an oxygen cylinder into the oxygen cylinder
holder, tighten the thumb screw knobs properly. Otherwise, the
oxygen cylinder may move unexpectedly or drop, resulting in an
injury or damage.
z
z
The load capacity of the oxygen cylinder holder is 15kg. Do not
insert a cylinder that exceeds the load capacity because it may
damage or deform the oxygen cylinder holder or frame, resulting
in an injury.
