19
5
OPERATION PROCEDURES
To attach
1
Insert an IV Pole firmly all the way into an IV Pole
attachment hole.
2
Firmly lock the IV Pole by turning the thumb
screw knob (for locking an IV Pole).
WARNING
z
z
For an IV Pole to be directly
mounted on the stretcher, use
only accessories approved by
Paramount Bed. The use of
products other than the specified
suitable products or products
from other companies could
create unintended gaps, cause
interference between products,
or lower stability, resulting in
injury or damage to the stretcher.
z
z
Insert an IV Pole firmly all the way
at a specified attachment position
and firmly tighten the thumb screw
knob (for locking an IV Pole). If an
IV Pole is used in an insufficiently
inserted or locked state, it may
unintentionally fall or become
detached, resulting in injury.
Furthermore, when the backrest
is lowered, the IV Pole may come
into contact with it, resulting in
damage to the IV Pole.
To use
1
Loosen the thumb screw knob (for locking the
sliding pipe) of the IV Pole, adjust the sliding
pipe length, and then lock the sliding pipe by
tightening the loosened thumb screw knob.
WARNING
z
z
When loosening the thumb
screw knob, firmly grip the
sliding pipe (upper part of
the support pole). The sliding
pipe may unintentionally fall,
resulting in injury.
CAUTION
z
z
Adjust the sliding pipe length
to within 400 mm. Pulling the
sliding pipe out too far could
cause it to come off, resulting
in injury or damage.
8. IV Pole (C57E)
z
IV Pole attachment holes are located in two places each on the left and right sides of the
stretcher, four places in total, to attach an IV Pole for intravenous drip.
z
When not using an IV Pole, you can store it either in the IV Pole storage holder or tray.
z
z
Stretcher viewed from above
IV Pole attachment hole (4 locations)
Transfer board
IV Pole (C57E)
IV Pole attachment
hole
Insert
Thumb screw knob
(for locking an IV Pole)
Do not insert an IV Pole into
the attachment part of the
oxygen cylinder holder.
Tighten
Thumb screw knob
(for locking the sliding pipe)
Sliding pipe
Loosen
Tighten
Product ID label (affixed to support pole)
* The model number of the IV Pole is
printed on the product ID label.
