Panther PN-6730-UXP, User Manual

Page: 111 / 176

101
Zoom Control
80 Zoom All Edges ZAI ZAO Zoom all edges: I (letter) = In, O = Out
81 Zoom, Left Edge ZLU ZLD
After all 8 settings have been sent, send XGO
(letter O) to ’make it so.’ If the high byte is
zero, it does not need to be sent.
82 Get/Set Left Edge (high byte) Z0$ X0#
83 Get/Set Left Edge (low byte) Z1$ X1#
84 Zoom, Right Edge ZRU ZRD
85 Get/Set Right Edge (high
Byte)
Z2$ X2#
86 Get/Set Right Edge (low byte) Z3$ X3#
87 Zoom, Top Edge ZTU ZTD
88 Get/Set Top Edge (high byte) Z4$ X4#
89 Get/Set Top Edge (low byte) Z5$ X5#
90 Zoom, Bottom Edge ZBU ZBD
91 Get/Set Bottom (high byte) Z6$ X6#
92 Get/Set Bottom Edge (low
byte)
Z7$ X7#
Video Decoder
93 Brightness D1U D1D
–128 to 127; –16 is default
94 Get/Set Brightness F2$ E2#
95 Contrast D2U D2D
0 to 63; 48 is default
96 Get/Set Contrast F4$ E4#
97 Saturation D3U D3D
0 to 4095; 2070 is default. Send high byte
first. Display is updated when the low byte is
sent.
98 Get/Set Saturation (high byte) F5$ E5#
99 Get/Set Saturation (low byte) F6$ E6#
100 Hue D4U D4D
–512 to 512; 0 is default. Send high byte first.
Display is updated when the low byte is sent.
101 Get/Set Hue (high byte) F7$ E7#
102 Get/Set Hue (low byte) F8$ E8#
Audio Controls
103 Volume
VAU VAD VA$ SV# # = 0 – 100
VAU and VAD adjust volume by one unit of
audio resolution. Volume has 51 steps, so
there will be no difference between com-
mands when the data differs by one.
104 Mute VM1 VM0 VM* 0 = Mute off, 1 = Mute on
105 Loudness VL1 VL0 VL* 0 = Loudness off, 1 = Loudness on
106 Treble TAU TAD TA$ ST# See comments for volume. Treble has 17
steps.
107 Bass BAU BAD BA$ SB# See comments for volume. Bass has 21
steps.
108 Balance, internal BIU BID BI$ SI# See comments for volume. Balance has 52
steps.
0-50 is balance toward left side.
109 Balance, external BEU BED BE$ SE# See comments for volume. Balance has 52
steps.
0-50 is balance toward left side.
R
o
w Function
RS232
Commands RS232 Data
Comments Incr Decr Get Set