Panther PN-6730-UXP, User Manual

Page: 107 / 176

97
12 Lamp Count (Set lamp count to
number of lamps desired.)
Lamp Mask (Get ’mask’ of which
lamps are supposed to be on.
See also, Lamp Status, for
actual state of each lamp.)
LC$ LC# Set # = binary (hex) 1 or 2
Get $ is a bit mask showing which lamps are
enabled, not how many. Does not deter-
mine which lamps are actually on. (See
Lamp Status command)
3 in hex=0011 binary, both lamps
2 in hex =0010 binary, rear lamp
1 in hex = 0001 binary, front lamp
Etc.
13 Lamp Status LA@ Send LA@, where @ is lamp number, 1 or 2
Responses are:
LAN = lamp on
LAF = lamp off
LAK = lamp striking
LAS = lamp shutting down
LAD = lamp failed
14 Read Lamp Hours L@$ (see Com-
ments)
Requires two commands to get value:
L1$ = Get Front Lamp high byte
L2$ = Get Front Lamp low byte
L3$ = Get Rear Lamp high byte
L4$ = Get Rear Lamp low byte
15 Lamp Hours Reset LR@ Reset Lamp Hours to zero
@ = Lamp number, or S = all lamps
16 Read System Hours (low byte) TL$
17 Read System Hours (high byte) TH$
18 Read Runtime Hours (low byte) RL$
19 Read Runtime Hours (high byte) RH$
R
o
w Function
RS232
Commands RS232 Data
Comments Incr Decr Get Set