Panasonic YD-500GP5, Operating Instructions Manual

Page: 39 / 64

Settings
35
【
INIT
·
CRATER
】
NO. Menu contents Set range Increment Default Note
P06
CRATER
REPEAT
0 or 1 1 0
1: enabled, 0: disabled.
（
Chapter 8
）
P07
CRATER
REPEAT
TIME
0 s
～
5 s
1 s 2 s
The setting of the value of the time of
closing arc repeating.
P14
Crater linkage
percentage
0
～
200
1 0
NOT 0: The arc current is [Welding current]
* [Setting value] %; 0: The closing arc
current is the setting of [Arc current value].
Note: After the linkage percentage is set,
the arc current does not exceed the
maximum welding current limit [350 A /
500 A]
P13
INIT linkage
percentage
0
～
200 1 0
Not0: Initial current is [Welding current] *
[Setting value] %;
0: Initial current is the set [Initial current
value].
Note: After the linkage percentage is set,
the initial current will not exceed the
maximum value of the welding current [350
A / 500 A]
P27
INIT·CRATER
Switch
0 or 1 1 0 1
：
AUTO 0
：
Manual
【
Others
】
NO. Menu contents Set range Increment Default Note
P24 Arc shape -99
～
99 1 0
The higher value you set, the more
concentrated arc you get
；
The lower, the
less concentrated arc.
P25
Welding display
mode
0 or 1 1 0
0 stands for current and voltage display ;1
stands for energy display [P=U*I].
P28 Reserve.
P29
Deepen test
welding function
enabled
※
6
0 or 1 1 0
1: enabled, 0: disabled.
Test welding can last for 3 hours Deepen
function
※
6 P29 ( Deepen Trial function enabled )
When the accumulated welding time reaches 3 hours after the timer for trial starts, this function is disabled. If you desire to
continue, please contact with distributor to activated this function.