15
For BNC cable connection
Use only the recommended plug below when connecting the
BNC plug to the connectors on the rear panel of the record-
er.
Applicable plug: MIL-C39012C or MIL-C39012/16F
* Suffixes attached to the standards may be updated.
Tip dimensions inside the recommended BNC plug
Important:
• A compatible plug shall be used. Failure to observe this
may cause trouble such as poor contact. At worst, the
connector of this product may be damaged.
Avoid placing receptacles that contain liquids such as
water near this product.
If liquid spills onto this product, it may cause fire or an elec-
tric shock.
Grounding
Confirm that the wire is connected from the SIGNAL GND
terminal to earth ground.
A grounding connection must be made before connecting
the power plug or this product to the main power supply.
When disconnecting the grounding wire, make sure that the
power plug of this product is disconnected from the main
power supply.
Plug
BNC cable (locally procured)
ø1.32 mm - ø1.37 mm
ø0.13 mm - ø0.69 mm
Plug
BNC cable (locally procured)
ø1.32 mm - ø1.37 mm
ø0.13 mm - ø0.69 mm
Summary of Contents for WJ-HD616/1000
Page 155: ...155...
