117
Setting the detection depth
Set the detection depth of the detected areas. By setting the detection depth, it is possible to automatically calculate the size of
object to be detected on the screen to reduce the detection failure.
To calculate the detection depth properly, mount the camera horizontally.
Step 1
Display the setup page for camera's i-VMD function, and
select the desired camera and scene. (
+
Page 114)
Step 2
Select the [Detection depth] tab.
→
The [Detection depth] tab will be displayed.
Step 3
Select the [Setup] button.
→
The depth setup page will be displayed.
Step 4
Draw 2 square markers between the nearer sides (lower
areas in the image) and the farther sides (upper areas in the
image). Click the upper-left corner and lower-right corner of
each square markers.
Normally, assuming that people go forward and backward, it
is possible to calculate the correct depth by drawing the
larger marker for the nearer side and the smaller marker for
the farther side.
Note:
• Markers will be displayed according to the grid for the
setting of the SD5 camera. It may be possible that the
actual markers will not be exactly the same as the desig-
nated positions.
• Markers will be displayed in 3:1 (width: height).
• To retry drawing markers, select the [Cancel] button.
→
When the markers are drawn, the calculation result is
displayed in a virtual horizon. (Depending on the marker
sizes and positions, the line may not be displayed.)
Step 5
To close the depth setup page, select the [Back] on the
upper right corner on the screen.
→
Closes the depth setup page and returns to the
[Detection depth] tab.
Important:
• Before using the depth correction function, test the per
-
formance of detection after the setting.
Summary of Contents for WJ-HD616/1000
Page 155: ...155...
