Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 69
2)
Raise the power cord holder fixing the power cord upward. (Fig. 1)
f
Fix the power cord holder by snapping into the projector.
3)
While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector. (Fig. 2)
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Indicator status
Projector status
Off
The main power is switched off.
Red
Lit
The power is switched off. (standby mode)
Projection will start when the <POWER ON> button is pressed.
f
The setting of the projector is as follows.
g
The [PROJECTOR SETUP] menu
→
[QUICK STARTUP] is set to [OFF].
f
The projector may not operate when the light source indicators <LIGHT1> / <LIGHT2>
or the temperature indicator <TEMP> are blinking. (
x
page 267)
Blinking
The power is switched off. (standby mode)
Projection will start when the <POWER ON> button is pressed.
f
The projector is in one of the following states.
g
The [PROJECTOR SETUP] menu
→
[QUICK STARTUP] is set to [ON].
g
The output image corresponding to the projected image from the projector is being
check by the web control function. For details, refer to “[Remote preview lite] page”
(
x
page 225)
.
f
The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set to the following. However, the
indicator will not change to a red light while the output image is being checked by the
web control function.
The specified time is the time set in the [PROJECTOR SETUP] menu
→
[QUICK
STARTUP]
→
[VALID PERIOD].
g
The [PROJECTOR SETUP] menu
→
[QUICK STARTUP] is set to [ON].
f
The projector may not operate when the light source indicators <LIGHT1> / <LIGHT2>
or the temperature indicator <TEMP> are blinking. (
x
page 267)
Green
Lit
Projecting.
Orange
Lit
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)
Note
f
While the power indicator <ON (G)/STANDBY (R)> lights orange, the fan is running to cool the projector.
f
For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks red.
f
The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks red). Refer to “Standby mode
power consumption” (
x
page 291) for the standby mode power consumption.
Power indicator <ON (G)/STANDBY (R)>
