Chapter 4
Settings — [PROJECTOR SETUP] menu
174 - ENGLISH
*3 This item can be selected when the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in <SLOT>.
*4 This item can be selected when the optional Wireless Presentation System Receiver Board (Model No.: TY-SB01WP) is installed in <SLOT>.
*5 This item can be selected when the Function Board by other manufacturers is installed in <SLOT>.
*6 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK IN/
LAN> terminal of the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) installed in <SLOT>, its input name is automatically
reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press
as
to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The
[DATE AND TIME]
screen is displayed.
3) Press
as
to select [TIME ZONE].
4) Press
qw
to switch [TIME ZONE].
Note
f
The [TIME ZONE] setting is reset to the factory default setting when the projector is initialized by one of the following methods. However, the
date and time based on the local date and time setting (Coordinated Universal Time, UTC, Universal Time, Coordinated) will be maintained
without being initialized.
g
When initialized by selecting the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[FACTORY RESET]
g
When initialized by setting the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[USER SETTINGS]
→
[OTHER USER SETTING] to
[INITIALIZE]
Setting the date and time manually
1) Press
as
to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The
[DATE AND TIME]
screen is displayed.
3) Press
as
to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f
The
[ADJUST CLOCK]
screen is displayed.
5) Press
as
to select an item, and press
qw
to set the local date and time.
6) Press
as
to select [APPLY], and press the <ENTER> button.
f
The setting of the date and time will be completed.
Note
f
The replacement of the battery inside the projector is required when the time goes out of alignment right after correcting the time. Consult
your dealer.
Setting the date and time automatically
To set the date and time automatically, the projector must be connected to the network.
1) Press
as
to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The
[DATE AND TIME]
screen is displayed.
3) Press
as
to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f
The
[ADJUST CLOCK]
screen is displayed.
5) Press
as
to select [NTP SYNCHRONIZATION], and press
qw
to change the setting to [ON].
