Chapter 2
Getting Started — Installing the Function Board
58 - ENGLISH
Removing the SFP module
The following is an example of removal procedure for the SFP module. Please also check the operating
instructions and setup guide of the SFP module.
Fig. 1
Fig. 2
1) Disconnect the optical fiber cable.
f
If the optical fiber cable is connected to the SFP module, remove the cable while releasing the latch of the
optical fiber cable.
2) Release the latch of the SFP module. (Fig. 1)
f
Pull down the lever on the SFP module to release the latch.
3) Remove the SFP module. (Fig. 2)
f
Hold the lever and slowly pull out the SFP module.
Attention
f
Make sure to attach the port cover on the SFP port that the SFP module is not installed.
f
Store the removed SFP module with the protection cap, etc., attached so that dust does not accumulate or the SFP module does not get
dirty.
Latch
Lever
SFP modules
Lever
