Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 131
r
PT-MZ10K
[LIGHT OUTPUT] (%)
Brightness (lm)
Estimated runtime
*1
(hours)
100.0
10 000
20 000
80.0
8 000
21 500
60.0
6 000
23 000
40.0
4 000
25 000
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu
→
[DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
30.0
Estimated runtime (hours)
25 000
24 000
23 000
22 000
21 000
20 000
40.0
4 000
50.0
60.0
[LIGHT OUTPUT] (%)
Brightness (lm)
70.0
80.0
90.0
100.0
10 000
Note
f
The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f
If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
[LIGHT OUTPUT]
Adjust the brightness of light source.
The setting is reflected when it is already set with “Initial setting (operation setting)” (
x
page 58) in the
[INITIAL
SETTING]
screen or with the [PROJECTOR SETUP] menu
→
[OPERATION SETTING]. The [LIGHT OUTPUT]
setting is synchronized with the [PROJECTOR SETUP] menu
→
[OPERATION SETTING]
→
[LIGHT OUTPUT].
The most recent setting is reflected in both items.
1) Press
as
to select [LIGHT OUTPUT].
2) Press
qw
to adjust.
Operation
Adjustment
Range of adjustment
Brightness
Runtime (estimate)
Press
w
.
The screen becomes brighter.
The runtime becomes shorter.
8.0 % - 100.0 %
Press
q
.
The screen becomes darker.
The runtime becomes longer.
Note
f
[LIGHT OUTPUT] can be adjusted individually for each setting item of [OPERATING MODE].
f
The uniformity of the brightness between multiple screens can be maintained by adjusting [LIGHT OUTPUT] for each projector when
structuring a multi-display screen by combining the projected images from multiple projectors.
[STANDBY MODE]
Set the power consumption during standby.
1) Press
as
to select [STANDBY MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Select this item when using the network function during standby.
[ECO]
Select this item to reduce power consumption during standby.
Note
f
When [ECO] is set, the network function, the <SERIAL/MULTI PROJECTOR SYNC OUT> terminal, and some RS-232C commands become
inoperable during standby. When [NORMAL] is set, the network function and the <SERIAL/MULTI PROJECTOR SYNC OUT> terminal can
be used during standby.
