Panasonic KX-TD816E, Installation Manual

Page: 470 / 600

4.9 LCR Programming
Authorization Code Set
7X24
4-156 System Programming
Description
Registers an authorization code applied to a CO line.
The registered code is inserted into the “A” command position
stored in program [7X22] “LCR Carrier Modify Command.”
Selection
• Program address: 7X24, X=1-8 (carrier number)
• CO line number:
KX-TD816 – 01 through 08, ( =all CO lines)
KX-TD1232 – 01 through 24, ( =all CO lines)
• Authorization code: 20 digits (max.)
Default
All programs – Not stored
Programming
1. Enter a program address (7X24).
Display example: Authorize Code C1
2. Press NEXT.
Display example: CO Line NO?–>
3. Enter CO line number.
To enter CO line number 01, you can also press NEXT.
Display example: CO01: Not Stored
4
. Enter an authorization code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new code.
5. Press STORE.
6. To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions
• There is a maximum of 8 CO lines for KX-TD816 and 24 CO lines for
KX-TD1232, each of which can be given an authorization code.
• Each authorization code has a maximum of 20 digits, consisting of
0 through 9 and PAUSE.
• To assign one authorization code to all CO lines, press the key at
step 3. In this case, the display shows the contents programmed for
CO01.
• If the authorization code is already stored, “Already Set” is displayed at
step 3.
• To display parts of the commands which have scrolled off the display,
press or .
Feature References
Section 3, Features,
Least Cost Routing (LCR)