Panasonic KX-NS1000, Feature Manual

Page: 116 / 482

Service Number of Ports Load (Busy Ratio %) DSP Cost
*1
CO line using G.729 codec 3 5% 0.3
Non-IP CO line 1 5% 0.05
Extension using G.729 codec 32 10% 7.0
Unified Messaging 4 — 5.2
OGM 2 — 4.0
Conference 4 — 2.0
Total DSP Cost 18.55
*1 DSP Cost = Number of Ports
´
Resource cost per port (unit)
´
Load
In the example above, the total DSP cost is 18.55. In such an environment, a PBX with a DSP S card (max.
63 DSP resources) would be sufficient.
Example 2: Call Center
In a call center, both the number of CO lines and number of extensions are likely to be very high. Also, since
employees are constantly receiving calls, the system load will be high. Furthermore, calls are often recorded
at call centers to provide quality-of-service monitoring.
Service Number of Ports Load (Busy Ratio %) DSP Cost
*1
CO line using G.729 codec 8 50% 8.8
CO line using G.711 codec 128 80% 102.4
Extension using G.729 codec 32 50% 35.2
Extension using G.711 codec 128 80% 102.4
IP-CS using G.729 codec 8 50% 8.8
Unified Messaging 8 — 10.4
Two-way recording 4 — 9.2
OGM 4 — 8.0
Conference 12 — 6.0
Total DSP Cost 291.2
*1 DSP Cost = Number of Ports
´
Resource cost per port (unit)
´
Load
In this example, the total DSP cost is 291.2. In this case, two DSP cards are necessary: at minimum one DSP
L card (max. 254 DSP resources) and one DSP S card (max. 63 DSP resources).
Conditions
•
Calls that are established via P2P (
®
15.1.5 Peer-to-Peer (P2P) Connection) do not use the PBX’s DSP
resources, so they may be excluded from the usage calculation.
•
One-look Networking (
®
14.1.4 One-look Network)
Since DSP resources are not shared between PBXs, the resource advisor should be used to calculate the
resource usage for each PBX individually.
116 Feature Manual Document Version 2016-03
5.1.16 DSP Resource Advisor