- 33 -
2
Rotate the CONV. dial to adjust the
convergence point.
≥
This can be set between C00 and C99. Position of the
convergence point will be set further when the number
is larger.
≥
The subject at the position of the convergence point will
not shoot out or recess from the screen. (It will be seen
in the same way as 2D image.)
≥
Adjust by checking on the 3D image or 3D guide display
on the LCD monitor. (
l
34)
≥
When zooming, it may be necessary to readjust the convergence point.
About Convergence Reset
When a convergence reset is performed, the display of the convergence point goes to
,
and the convergence point is automatically set to prevent 3D video that causes tiredness or
discomfort to the viewer. When the zoom magnification is changed, the convergence point is
adjusted automatically, so please use this setting if you wish to record subjects which are far
away without worrying about convergence. (
l
66)
≥
Optimal distance range for subject at Convergence Reset.
* This is the target when the [3D GUIDE] is set to [MODE1]. (
l
34)
To adjust the convergence point with MIX display
Images from the left and right lenses are displayed overlapping when the 3D display is set to
MIX display. Adjust the convergence point so the outlines of the subject to be the reference
plane are overlapping exactly.
≥
The left and right images will not be perfectly aligned if the subject is located at a distance
of less than approximately 45 cm.
≥
Please refer to page 65 for information on the 3D display.
≥
3D image can be recorded as close as approximately 45 cm from the lens when the zoom
magnification is set to 1
k
.
Zoom magnification
Optimal distance range between this unit and the
subject
*
1
k
(Z00)
approximately 0.9 m or further
4
k
(Z70)
approximately 3.4 m or further
8
k
(Z92)
approximately 6.7 m or further
10
k
(Z99)
approximately 8.3 m or further
CONV.
