Panasonic FP? Positioning Unit RTEX, Technical Manual

Page: 233 / 288

17-19
17.4.9 Positioning Control Area
-
This is the area to set the repeat count of the positioning control to be started by axis.
-
The positioning unit repeats the started positioning control for the specified repeat count and then
completes the operation. The repeat count is changed to the default value on completion of the
operation.
Bank
Offset
address
Name Descriptions
Default
value Setting
range
Unit
00H
108H
Positioning
repeat count of
axis 1
Stores the number of times for repeating the
operation starting from the position control starting
table number of the first axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
109H
Positioning
repeat count of
axis 2
Stores the number of times for repeating the
operation starting from the position control starting
table number of the second axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
10AH
Positioning
repeat count of
axis 3
Stores the number of times for repeating the
operation starting from the position control starting
table number of the third axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
10BH
Positioning
repeat count of
axis 4
Stores the number of times for repeating the
operation starting from the position control starting
table number of the fourth axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
10CH
Positioning
repeat count of
axis 5
Stores the number of times for repeating the
operation starting from the position control starting
table number of the fifth axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
10DH
Positioning
repeat count of
axis 6
Stores the number of times for repeating the
operation starting from the position control starting
table number of the sixth axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
10EH
Positioning
repeat count of
axis 7
Stores the number of times for repeating the
operation starting from the position control starting
table number of the seventh axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times
10FH
Positioning
repeat count of
axis 8
Stores the number of times for repeating the
operation starting from the position control starting
table number of the eighth axis until the E point.
When 255 is stored, the positioning control is
repeated unlimitedly until the operation is stopped.
0 0 to 255 times