101
Settings for energy saving
Energy saving
The “I/D unit cyclic” screen
A: [Select all]/[Clear all] buttons
[Select all]
Select all indoor units.
[Clear all]
Cancel selection of all indoor
units.
B: Set whether to enable indoor unit cycling
control across the whole system or not.
Note
y
If you select “Yes”, make sure that you
set “No” for outdoor unit cycling control
settings.
C: Change list order. The list order changes
each time you touch it.
Display
The display follows the order set
in “I/D unit settings” (P.141).
O/D unit
The display follows the outdoor
unit display order set in “O/D unit
settings” (P.145).
Address
The display follows the address
order set in “I/D unit settings”
(P.141).
D: The indoor units with a check mark next to
them will be the subject of the changes to the settings.
E: The I/D unit cyclic is enabled for the selected indoor unit if you put a check mark here. This is linked with the “I/D unit cyclic Valid”
(“Setting” dialogue) (P.99) setting.
F: The “Term setting” dialogue is displayed when you touch this.
G: The “Setting” dialogue is displayed when you touch this.
A
G
F
B
C
D
E
Control operation at regular intervals [I/D unit cyclic]
