Panametrics HydroProII, User Manual

Page: 32 / 104

Chapter 2. Operation
20 HygroPro
II
User's Manual
If it does appear for a new HygroPro
II
installation, please contact Panametrics Technical support to check the
calibration date of the probe (Serial number engraved).
As shown below the !CR symbol flashing on the display in the specific spot on the top line indicates the probe is due
for recalibration. Note this reminder occurs on the same location on the display regardless of its format (i.e., single
view or triple view).
If the user selects the !CR reminder by navigating to it on the display using the Up arrow, then the description of the
calibration reminder is displayed along with the Panametrics web page URL.
2.2.2 Selecting Measurement Parameters
To select the measurement parameters, complete the following steps:
Since the HygroPro
II
does not use a real-time clock battery, the clock
needs to be set upon power up. If the user chooses either 6 months or
1 year, they are then required to entire the current time and date to
ensure accuracy of the calibration reminder.
When the calibration reminder feature is enabled (i.e., User does not
choose SKIP), the User is required to enter only the month and the year
of the current date by selecting either field, and using the Up or Down
arrows to change it. Pressing the Enter key saves the current date and
time.
If the date and time are saved to the device non-volatile memory
correctly, depending on the calibration date of the HygroRTE probe
attached, the !CR calibration reminder warning will not appear on the
display as shown.
To enter the main menu press Escape

.
To select the number of measurements to be displayed on each
screen, select # of Views and press
Enter .
Use the up and down keys to select the number of views desired and
press
Enter .

