Panametrics CGA 351, User Manual, Page: 53 / 119

CGA 351 User’s Manual 47
Chapter 4.
Setting Fault Alarm Type (cont.)
The meter now automatically returns to the “User” prompt. Either press [ESC] until you exit the
User Program or
proceed to the appropriate section to continue setting up the user options.
4.1.9 Setting Up the Analog Output
To set up the CGA 351’s analog output, enter the User Program (see page 27) and proceed as follows:
Note: The
[Backlight]
and
[Comm]
options are also available in the above list box.
Table 74:
User Fault-Alarm Use the [

] and [

] keys to
select the desired alarm type
and press [ENTER] .
Non Fail-Safe
Fail-Safe
POWER ESC ENTER
Table 75:
Cfg Cal
Opt
Disp Use the [

] and [

] keys to
select [Opt] and press
[ENTER] .
POWER ESC ENTER
Table 76:
Cfg Cal
Opt
Disp A list of the available options
is shown. Use the [

] and [

]
keys to select [User] and
press [ENTER] .
User
Setup
Lock Menus
POWER ESC ENTER
Table 77:
User Use the [

] and [

] keys to
select [Analog Output] and
press [ENTER] .
Fault Alarm
Analog Output
Contrast
POWER ESC ENTER