Panametrics CGA 351, User Manual, Page: 41 / 119

CGA 351 User’s Manual 35
Chapter 4.
4.1.5.1 Entering the Setpoint
Read the CAUTION! on page 34. Enter the temperature control menu as described there and proceed as follows:
Note: The [Select Gas Type], [Prop Band] , [Int Time]
,
[Max.Duty Cycle] and [Default] options are also available in the
above list box.
At the next prompt, enter the desired operating temperature for the analyzer. Usually, this is a 700–780°C oxygen
sensor temperature.
IMPORTANT: Calibrating the meter automatically adjusts the value of the setpoint temperature.
The meter now automatically returns to the “Temp. Control” prompt. Either press [ESC] until you exit the
User Program
or proceed to the appropriate section to continue setting up the temperature control.
Table 40:
Temp-Cntrl Use the [

] and [

] keys to
select [Setpoint] and press
[ENTER] .
Setpoint
Sensor Temp
Air Offset
POWER ESC ENTER
Table 41:
Temp-Cntrl...Set Point Using the [

] and [

] keys,
position the cursor under the
desired character. Then, use
the [

] and [

] keys to
increment the value. When
done, press [ENTER] .
Setpoint
000
p
POWER ESC ENTER
Table 42:
Temp..Invalid-Output This message indicates that
changes in this menu will alter
the live data output. Press
[ENTER] to continue.
Modifying value may
cause invalid output
OK
Can -
cel
POWER ESC ENTER
Table 43:
Tem..Unit-Measuring This message indicates that
changes in this menu will alter
the live data output. To
accept the new value, use the
[

] and [

] keys to select
[Yes] and press [ENTER] .
Unit measuring
Accept changes?
Yes
No Cancel
POWER ESC ENTER