PALSON CANDY, Operating Instructions Manual

Page: 7 / 28

7
Preheating
1. Rest the metal curling tong on a flat, smooth surface and plug the appliance into the mains.
. Turn on, set to the required temperature and allow the metal curling tong to heat; it takes about 60-90 seconds to heat.
3. The LED stops blinking and stays lit continuously when the set temperature has been reached.
Temperature settings
Press the “+” button to increase the temperature setting. Press the “-” button to lower the temperature setting. The
temperature LEDs blink to indicate the temperature chosen. When the required temperature setting is reached, the
temperature LEDs stop blinking and remain lit continuously.
Hair type Temperature setting
Very thick and wiry (High) 00º C
Thick, bushy, difficult to manage (Medium/High) 180ºC
Normal, in good condition (Medium) 160ºC/140ºC
Very fine, fragile, light-coloured (Low) 10º C
Note: If the operating LED is lit but all the temperature LEDs are off, the metal curling tong will not heat. You must press
the “+/-” button to heat the tong.
Warning: Be very careful when using the tong as it becomes very hot at the highest temperature setting.
USE IN THE HAIR
Divide the wet or dry hair evenly into several sections and comb uniformly. Press the thumb button and place the tong so
that it holds half of a section of hair and distribute the hair evenly between the flat surface and the round surface. When
the hair is placed as required, release the button so that the hair is firmly held between the flat surface and the round
surface.
Gently slide the metal tong down towards the end of the hair. To avoid curling the ends, make sure that they are firmly
coiled underneath the flat surface in the desired direction of the curl. Always remember to place the flat surface on top of
the section of hair when you want to curl the hair inwards; place the flat surface underneath the section when you want
a more playful style.
Coil the hair to the length you wish to curl, making sure that the flat surface does not touch the scalp. Hold for about 5-8
seconds, depending on the texture and length of the hair. For a denser, more marked wave, coil less hair. For a free,
bouncier curl, coil more hair.
To remove the tong, press the button with the thumb to release and pull out the tong. To “set” the curl, do not comb or
brush the hair until it has cooled.
CARE AND CLEANING
This product contains parts that cannot be repaired by the user. Consult an authorised service centre.
Cleaning
1. Unplug the appliance and allow the metal curling tong to cool. The tong should only be cleaned when fully cooled.
2. Use a soft, slightly damp cloth to clean the handle. Do not allow water or any other liquid to enter the handle.
3. If material should build up, clean the tong with a mild, gentle soap or a special cleaning fluid and wipe with a soft
cloth.
Storage
1. Unplug the appliance, allow to cool and store in a clean, dry place.
. Coil the power cord loosely.
3. Never coil the power cord around the appliance; this will cause wear and premature cord breakage.
4. Never strain the power cord in the area where it enters the handle. This will cause rubbing and breakages.
5. Never hold the appliance by the power cord.
Thank you for choosing one of our products.