paladin Sweepster CTM4800, Operator And Parts Manual

Page: 60 / 62

60
51-3000
GLOSSARY
angle or angle assembly - portion of the sweeper
that allows the brush head assembly to angle.
BP - black pipe.
brush head assembly - assembly that includes the
core, hood, and brush frame.
brush pattern - area of dirt removed from sweeping
surface; with a properly adjusted sweeper; the
pattern is the same width for the entire length.
castellated
- having battlements like a castle.
caution - indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury.
core - weldment that holds brush sections.
danger - indicates an imminently hazardous
situation which, if not avoided, will result in death or
serious injury.
F - female.
FS - face seal.
front - side that is in front when facing the normal
forward direction of travel of the machine.
gpm - gallons per minute.
HP - high pressure.
hood - brush shield.
hydraulic angle kit
- means of swinging an
assembly hydraulically
in . - inch.
kph
- kilometers per hour.
lb - pounds.
left-hand - side that is on left when facing the
normal forward direction of travel of the machine.
lift cylinder
- means of raising the brush head
assembly hydraulically.
lps - liters per second.
M
- male.
mm - millimeters.
mph - miles per hour.
manual angle kit - means of swinging the brush
head assembly mechanically.
mounting assembly - portion of the sweeper that
attaches to the primer mover; designed specifically
for each prime mover.
NPT - national pipe thread.
note
- indicates supplementary information.
notice - used for instructions when machine
damage may be involved.
psi
- pounds per square inch.
PTO - power take off; shaft on the prime mover
used to drive attachments.
prime mover
- refers to the tractor, truck, loader or
other vehicle to which a sweeper is attached.
qty - quantity.
quick change core
- core designed in a way
that allows brush sections to be changed without
removing hoses from motors.
rpm - revolutions per minute.
rear - side that is in the rear when facing the normal
forward direction of travel of the machine.
retainer - removable plate or set of plates that keep
sections on the core.
right-hand - side that is on the right when facing the
normal forward direction of travel of the machine.