paladin Sweepster CTM4800, Operator And Parts Manual

Page: 51 / 62

51
51-3000
OPTION - HYDRAULIC ANGLE KIT
Installation
Figure 1 shows the kit fully installed.
NOTICE: AVOID DAMAGE TO THE SWING
CYLINDER. Remove the manual
angle T-pin before installing the
hydraulic angle kit.
1. Remove the T-pin from the swing assembly by
driving out the roll pin and lifting the pin.
Install adapter fittings on both cylinder ports.
Install the flow restrictor fitting (figure 1) on the rear
adapter fitting. A restrictor fitting is necessary for
proper operation and to prevent damage to the
hydraulic swing kit.
4. Hook 1 hose to the restrictor fitting and 1 to the
front adapter fitting.
5. Place the swing cylinder on pins welded to the
swing assembly. Install a 3/4 inch flat washer
and cotter pin on each swing assembly pin to
secure the swing cylinder.
6. Connect hoses to the tractor hydraulics.
NOTE: Because of the numerous types of
quick coupler fittings available, the user
furnishes quick coupler fittings for this kit.
figure 1