paladin Sweepster CTM4800, Operator And Parts Manual

Page: 12 / 62

12
51-3000
INSTALLATION
8. Raise the brush head assembly using the lift
system. If the brush head assembly raises 4
inches (101mm) off the ground, the lift cable
is properly adjusted; otherwise, go to the next
step.
9. Adjust the cable.
• If the brush head assembly does not raise
enough, decrease the amount of cable
between the uprights.
• If the brush head assembly raises too much,
increase the amount of cable between the
uprights.
Spring Chain Assemblies & Lift Cable
Refer to figures 1 & 2.
1. Attach a spring to 1 end of each chain.
2. Hook the springs on the drive assembly upright.
3. Place chains on the brush head assembly
upright using the outside slots. Slide a pin in the
holes under the drive assembly upright to secure
the spring-chain assemblies; insert a hairpin clip
in the pin.
4. Route 1 end of the lift cable through the chain
link welded to the brush head assembly upright.
Loop the loose end around and secure it with a
cable clamp (figure 3).
CAUTION! INSTALL CABLE CLAMPS AS
SHOWN IN FIGURE 5; otherwise;
the cable could slip, possibly
damaging the sweeper or injuring the
operator.
5. Loop the other end through the link on the drive
assembly upright; secure it with a cable clamp.
6. Hook up the electric lift system or optional
hydraulic lift system.
7. Raise the brush head assembly using the lift
system. If the brush head assembly raises 4
inches (101mm) off the ground, the lift cable
is properly adjusted; otherwise, go to the next
step.
figure 1
figure 2
figure 3
figure 4