paladin Sweepster CTM4800, Operator And Parts Manual

Page: 10 / 62

10
51-3000
INSTALLATION
Spring-Chain Assembly, Transport Chain,
Lift Cable
Follow the instructions that match your sweeper.
Spring-Chain Assembly & Transport Chain
Refer to figures 1 and 2.
1. Connect 2, 26-link chains and 2 springs to form
a loop.
2. Place chains in the outside slots in the drive
assembly upright and in the brush head
assembly upright.
3. Place the 36-link transport chain in the center
slot in the drive assembly and in the brush head
assembly upright.
4. Slide a pin in the holes under the drive assembly
upright and a pin in the holes under the brush
head assembly. Insert a hairpin clip in each pin.
Spring-Chain Assembly & Lift Cable
Refer to figures 3 & 4.
1. Connect 2, 26-link chains and 2 springs to form
a loop.
2. Place chains in the outside slots in the drive
assembly upright and in the brush head
assembly upright.
3. Route 1 end of the lift cable through the chain
link welded to the brush head assembly upright.
Loop the loose end around and secure it with a
cable clamp (figure 5).
CAUTION! INSTALL CABLE CLAMPS AS
SHOWN IN FIGURE 5; otherwise;
the cable could slip, possibly
damaging the sweeper or injuring the
operator.
4. Loop the other end through the link on the drive
assembly upright; secure it with a cable clamp.
5. Hook up the electric lift system or optional
hydraulic lift system.
figure 1
figure 2
figure 3