13
51-3000
INSTALLATION
figure 5
figure 6
To Actuator (Red)
To Actuator (Yellow)
To Power
(Red)
To G round
(Yellow)
To Actuator (Yellow)
To Actuator (Red)
To Ground
(Yellow)
8. Adjust the cable.
• If the brush head assembly does not raise
enough, decrease the amount of cable
between the uprights.
• If the brush head assembly raises too much,
increase the amount of cable between the
uprights.
Spring-Chain Assembly & Standard Hydraulic Lift
Figure 4 shows assemblies fully installed.
1. Connect 2, 26-link chains and 2 springs to form
a loop (figure 5).
2. Place chains in the outside slots in the drive
assembly upright and in the brush head
assembly upright.
3. Attach adapter fittings to both cylinder ports, and
install elbow fittings on adapter fittings. Then,
attach hoses to the elbow fittings and install
quick coupler fittings on the hoses.
4. Place a shackle on the rod end of the cylinder;
then, attach the shackle to the brush frame
upright.
5. Place a shackle on the barrel end of the cylinder
and attach the chain to the shackle. Then, attach
the chain to the center slot in the drive mounting
assembly upright.
6. Connect quick coupler fittings to the front remote
hydraulic outlets on the tractor.
7. Completely collapse the cylinder to check for
adjustment.
• If the brush head assembly lifts 4 inches
(101mm) off the ground, the hydraulic lift is
properly adjusted.
• If the brush head assembly does not lift 4
inches (101mm) off the ground, adjust the
chain. To raise the brush head assembly
more, shorten the chain length between
the cylinder and upright. To lower the brush
head assembly, add to the chain length.
Electric Lift System
NOTE:
Sweepers for commercial turf tractors and
those with the hydraulic lift option do not
use an electric lift system.
1. Locate a convenient, open area on the tractor
dash to mount the lift switch.
NOTICE!
AVOID DAMAGE TO THE PRIME
MOVER.
Before drilling, check
behind the tractor dash to make sure
that you will not drill into any wires or
other objects.
2. Use a center punch to mark the lift switch
location. Drill a pilot hole with a 1/4 inch bit;
then, drill the finish hole with a 1/2 inch bit.
3. Insert the switch and secure it with a nut.
4. Route the control wires and connector to the
front of the tractor. If necessary, strap or tape
wires to the tractor frame to prevent them from
hanging down.
To Power
(Red)
Summary of Contents for Sweepster CTM4800
