paladin Sweepster CTM4800, Operator And Parts Manual

Page: 53 / 62

53
51-3000
OPTION - HYDRAULIC LIFT KITS
figure 1
Installation
Figure 1 shows the lift kit fully installed.
1. Remove the transport chain and/or electric lift, if
installed.
2. Attach adapter fittings to both cylinder ports, and
install elbow fittings on adapter fittings. Then,
attach hoses to the elbow fittings and install
quick coupler fittings on the hoses.
3. Place a shackle on the rod end of the cylinder;
then, attach the shackle to the brush frame
upright.
4. Place a shackle on the barrel end of the cylinder
and attach the chain to the shackle. Then, attach
the chain to the center slot in the drive mounting
assembly upright.
5. Connect quick coupler fittings to the front remote
hydraulic outlets on the tractor.
6. Completely collapse the cylinder to check for
adjustment.
• If the brush head assembly lifts 4 inches
(101mm) off the ground, the hydraulic lift is
properly adjusted.
• If the brush head assembly does not lift 4
inches (101mm) off the ground, adjust the
chain. To raise the brush head assembly
more, shorten the chain length between the
cylinder and the upright. To lower the brush
head assembly, add to the chain length.