paladin Sweepster CTM4800, Operator And Parts Manual

Page: 8 / 62

8
51-3000
INSTALLATION
figure 1
Mounting Assembly
Install the mounting assembly (figure 1) on the
tractor by the following instructions enclosed with
those parts. Then proceed to Drive Assembly
or Brush Head Assembly if your sweeper has a
mounting assembly that includes a gearbox.
Drive Assembly
NOTE:
Some mounting assemblies include a
gearbox. Skip to Installation: Brush Head
Assembly if this applies to your sweeper.
1. Position the drive assembly (figure 1) in front of
the mounting assembly with the gearbox up.
2. Place the rear of the drive assembly on the front
of the mounting assembly. Install a 3/8-16 x 1
1/2 inch cap screw, flat washer, lock washer
and nut in the center hole (figure 1), but do not
tighten the hardware completely.
3. Install 2, 3/8-16 x 1 1/2 inch carriage bolts, flat
washers, lock washers and nuts in the outer
holes, but do not tighten the hardware.
NOTE: If the mounting assembly includes angles
and an input shield, place angles on the
holes before installing hardware.
4. Connect the input driveline to the tractor
and to the gearbox on the drive assembly.
Follow instructions included with the mounting
assembly.
5. Tighten the cap screw, flat washer, lock washer
and nut.
6. Units with input drive shield - Place the input
drive shield (figure 2) over the input driveline.
Attach angle brackets to the input driveline
shield. To make installation easier, put the
washer, lock washer and nut toward the outside
of the shield.