paladin Sweepster CTM4800, Operator And Parts Manual

Page: 19 / 62

19
51-3000
MAINTENANCE
Schedule
Part Schedule
Daily
Every 8
Hours
Every 40
Hours
When
Necessary
Brush Head Assembly
- Check brush pattern; adjust
as necessary. (See Adjustments: Brush Height) Level
brush head. (See Adjustments: Leveling)
Drive Chain - Lubricate with oil or chain lubricant.
Drive Shaft - Lubricate universal joints with high-
quality grease. Tighten universal joint set screws.
Electric Lift System
- Inspect wires. Apply silicon
spray to connections.
Gearbox - Check oil level; fill with SAE 80-90 weight
oil. Inspect for oil leaks. Check end play in shafts.
Clean shafts and vent plugs.
Hardware - Check for and tighten loose hardware.
Hydraulic Lift Option - Inspect hydraulic hoses and
connections. Replace damaged or worn parts.
Mounting Assembly - Lubricate with high-quality
grease.
Safety Signs - Clean to keep instructions readable.
Swing Plate - Lubricate with high-quality grease.
Tractor Air Cleaner - Clean or replace according to
instructions in tractor’s owner’s manual.
V-Belt - Check tension. Replace ant worn belts.
General
For best performance, regularly maintain your
sweeper. Carefully follow recommendations listed in
this manual.
Lubricating Constant Velocity (CV) Drive Shaft
Lubricate with high-quality grease before starting
work and after every 8 hours.
Clean and grease the drive shaft before each period
of non-use.
To prevent freezing in winter, grease the shield
tubes.
Lubricating Gearbox
After the first 100 operating hours, drain the oil and
flush the gearbox with an approved, nonflammable,
nontoxic solvent. Refill with oil.
Following the first oil change, oil after every 2,500
operating hours or 6 months, whichever comes first.