80
Steps:
1. Mount the seat module using two Allen head screws.
2. Connect the seat module to the controller.
Properly reassemble all components upon completion of the work.
fig. 90 Mounting the seat module
6.16.7 Removing the seat tilt actuator
NOTICE
Risk of cable damage.
Take note of the cables attached to the seat frame with cable ties. Carefully
cut the cable ties with side-cutting pliers or a knife. Ensure that you do not damage the cables during
this process!
Preparation:
❒
Remove the seat cushion (see Section 6.15.1).
❒
Remove the seat plate (see Section 6.15.4).
❒
Raise or tilt the seat until the actuator mounts are freely accessible.
❒
Turn the control unit off.
❒
Remove the fuse (see Section 6.2).
Tools:
❒
Screwdriver for pan head screws
❒
Retaining ring pliers
❒
Rubber mallet
❒
Side cutting pliers
Steps:
1. Disconnect the seat function cables on the controller or seat module (AAM).
2. Open the cable ties.
3. Loosen two retaining rings on the mounting points at the top and bottom of the actuator,
respectively, and push out the bolts.
Summary of Contents for C1000 DS
Page 1: ...C1000 DS Service Instructions ...
Page 2: ......
