P
REPARING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
62
6.4 Preparing Welding Conditions
This section explains the setting process of basic welding conditions.
6.5 Memory Function of Welding Conditions
This section explains the memory function of welding conditions.
The welding power source is equipped with the function to register the welding conditions and reads them out for use.
The number of welding conditions that are able to be registered are 100 at maximum. Single welding condition can contain
the following information at registration:
•
Welding mode selected by the keys on operation panel (Shield gas/Wire/Crater/Penetration control, etc.)
•
Welding current/voltage for each welding sequence (
6.6.3
-
Setting welding parameter)
•
Part of internal function (
6.1.3
-
Internal function)
NOTE
•
When the analog remote control (optional) is connected to the machine, even if the stored
welding condition is read, the set values of the analog remote control apply to the welding
current and welding voltage of welding condition.
Check welding material suitable for the welding condition
(
10.3
-
Materials for Setting Welding Conditions)
↓
Setting wire material, shield gas, and travel speed
(
6.6.1
-
Welding mode setting)
↓
Setting wire diameter
(
6.6.1
-
Welding mode setting)
↓
Setting crater treatment
(
6.6.4
-
Crater setting
-
)
↓
Setting pre-flow (Setting gas discharge time)
(
6.6.3
-
Setting welding parameter)
↓
Setting initial condition (Setting welding current/voltage)
(
6.6.3
-
Setting welding parameter)
↓
Setting welding condition (Setting welding current/voltage)
(
6.6.3
-
Setting welding parameter)
↓
Setting crater condition (Setting welding current/voltage)
(
6.6.3
-
Setting welding parameter, 6.6.4
-
Crater setting)
↓
Setting post-flow (Setting gas discharge time)
(
6.6.3
-
Setting welding parameter)
↓
Registering the welding conditions set above as necessary
(
6.5
-
Memory Function of Welding Conditions)
CAUTION
•
The welding conditions (electronic data) stored by this function are susceptible to
occurrence of static electricity, impact, repair, etc., and there is a possibility that the
stored contents may be changed or lost. BE SURE TO MAKE A COPY FOR IMPORTANT
DATA.
•
Please note that OTC will not be liable for any alteration or loss of electronic
information.
•
The memory function of welding condition is not available if the welding method is "DC
TIG" or "DC STICK".
