![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-1250ajp/jlg-1250ajp_service-and-maintenance-manual_1655741155.webp)
SECTION 3 - CHASSIS & TURNTABLE
3121171
3-101
3.
Assemble rotor (8A), counterbore down if applicable,
into stator (8B), and onto wear plate (9) with rotor
splines into mesh with drive link (10) splines.
NOTE:
If the manifold side of rotor was etched during Torqlink
disassembly, this side should be up. If rotor is not etched
and does not have a counterbore, use the drive link spline
contact pattern apparent on the rotor splines to determine
rotor side that must be against the wear plate.
EXCESSIVE FORCE USED TO PUSH THE ROTOR VANES INTO PLACE COULD
SHEAR OFF THE COATING APPLIED TO THE STATOR VANE POCKETS.
4.
Assemble six vanes (8C), or as many vanes that will read-
ily assemble into the stator vane pockets.
5.
Grasp output end of coupling shaft (12) with locking pli-
ers or other appropriate turning device and rotate cou-
pling shaft, drive link and rotor to seat the rotor and
assembled vanes (8C) into stator (8B), creating the nec-
essary clearance to assemble the seventh or full comple-
ment of seven vanes. Assemble the seven vanes using
minimum force.
6.
Remove the two assembled bolts (1) if used to retain sta-
tor and wear plate.
Go
to
Discount-Equipment.com
to
order
your
parts