![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-1250ajp/jlg-1250ajp_service-and-maintenance-manual_1655741044.webp)
SECTION 2 - GENERAL
3121171
2-3
Component Disassembly and Reassembly
When disassembling or reassembling a component, complete
steps in sequence. Do not partially disassemble or assemble
one part, then start on another. Always recheck your work to
ensure nothing has been overlooked. Do not make any adjust-
ments, other than those recommended, without obtaining
proper approval.
Pressure-Fit Parts
When assembling pressure-fit parts, use an anti-seize or
molybdenum disulfide base compound to lubricate the mat-
ing surface.
Bearings
1.
When a bearing is removed, cover it to keep out dirt and
abrasives. Clean bearings in nonflammable cleaning sol-
vent and allow to drip dry. Compressed air can be used
but do not spin the bearing.
2.
Discard bearings if races and balls (or rollers) are pitted,
scored, or burned.
3.
If bearing is found to be serviceable, apply a light coat of
oil and wrap it in clean (waxed) paper. Do not unwrap
reusable or new bearings until they are ready to install.
4.
Lubricate new or used serviceable bearings before
installation. When pressing a bearing into a retainer or
bore, apply pressure to the outer race. If the bearing is to
be installed on a shaft, apply pressure to the inner race.
Gaskets
Check holes in gaskets align with openings in the mating
parts. If it becomes necessary to hand-fabricate a gasket, use
gasket material or stock of equivalent material and thickness.
Be sure to cut holes in the right location, as blank gaskets can
cause serious system damage.
Bolt Usage and Torque Application
1.
Use bolts of proper length. A bolt which is too long will
bottom before the head is tight against its related part. If
a bolt is too short, there will not be enough thread area
to engage and hold the part properly. When replacing
bolts, use only those having the same specifications of
the original, or one which is equivalent.
2.
Unless specific torque requirements are provided in this
manual, use standard torque values on heat-treated
bolts, studs, and steel nuts, in accordance with recom-
mended shop practices. (See Torque Chart Section 1.)
Hydraulic Lines and Electrical Wiring
Clearly mark or tag hydraulic lines and electrical wiring, as well
as their receptacles, when disconnecting or removing them
from the unit. This will ensure correct reinstallation.
Hydraulic System
1.
Keep system clean. If evidence of metal or rubber parti-
cles are found in the hydraulic system, drain and flush
the entire system.
2.
Disassemble and reassemble parts on clean work sur-
face. Clean all metal parts with non-flammable cleaning
solvent. Lubricate components, as required, to aid
assembly.
Go to
Discount-Equipment.com
to
order your
parts