![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-1250ajp/jlg-1250ajp_service-and-maintenance-manual_1655741150.webp)
SECTION 3 - CHASSIS & TURNTABLE
3-96
3121171
4.
Place housing (18) assembly into a soft jawed vise with
the coupling shaft bore down, clamping against the
mounting flange.
5.
On the Torqlinks™ assemble a
new
backup washer (17)
and
new
seal (16) with the seal lip facing toward the
inside of Torqlink™, into their respective counterbores in
housing (18) if they were not assembled in procedure 2.
ORIGINAL DESIGN LARGE FRAME, TF & TG TORQLINKS™ THAT DO NOT HAVE
BACKUP WASHER (25) WHEN DISASSEMBLED MUST BE ASSEMBLED WITH A
NEW BACKUP WASHER (17), NEW BACKUP WASHER (25), AND NEW SEAL (16).
6.
Assemble thrust washer (14) then thrust bearing (15)
removed from the Torqlink™.
NOTE:
Torqlinks™ require one thrust washer (14) with thrust bear-
ing (15). Coupling shaft will be seated directly against the
thrust bearing.
7.
Apply masking tape around splines or keyway on shaft
(12) to prevent damage to seal.
8.
Ensure a generous amount of clean corrosion resistant
grease has been applied to the lower (outer) housing
bearing/bushing (19). Install coupling shaft (12) into
housing (18), seating it against the thrust bearing (15) in
the housings.
Go
to
Discount-Equipment.com
to
order
your
parts