SECTION 3 - CHASSIS & TURNTABLE
3121171
3-21
3.14
DRIVE HUB - IF EQUIPPED WITH BONFIGLIOLI
NOTE:
After SN 0300134389 machines may be built with either
Bonfiglioli or Reggiana Riduttori wheel drive hubs. See Sec-
tion 3.15, Drive Hub - If Equipped With Reggiana Riduttori.
Do not use different hubs on the same machine.
Product Identification
The identification data of the hub is shown on a name plates on
the hub. Figure 3-16., Drive Hub Identification Plate shows
how the information is displayed.
The information stamped on the name plates must always be
readable. Use the identification data (at least serial number)
for spare part inquiries, information and service, etc.
Hydraulic Motor Installation
The mating areas and the pilot diameter of the gearbox
where the motor is to be mounted must be clean and without
burrs.
Before assembling the hydraulic motor, verify by a depth slide
gauge the correct assembly of the unit checking the axial dis-
tance as shown in Figure 3-17.
1.
Fit the O-ring seal, supplied with the gearbox, in its seat
in the hydraulic motor, and assemble it to the gearbox
being careful not to damage the seal already fitted.
2.
Torque bolts to 63.5 ft-lb (86 Nm) torque.
Installation of the Wheel Drive on the Machine
1.
Clean the mating surfaces from oils or paint and fit the
wheel drive on the machine frame.
2.
Attach the gearbox to the machine frame with the
mounting bolts and torque to 178 ft.lbs. (241 Nm).
Start Up and Running In
If new hubs are being installed, it is advised to follow the
measures given below:
1.
Bleed air from every part of the hydraulic and add oil in
the tank if necessary.
THE PRESENCE OF RESIDUAL AIR IN THE HYDRAULIC CIRCUIT WILL BE REC-
OGNIZED BY THE PRESENCE OF FOAM IN THE TANK AND WILL LEAD TO A
JERKING OF THE MOTOR AS WELL AS EXCESSIVE NOISE COMING FROM THE
MOTOR AND THE VALVES.
2.
Start the gearmotor at a low speed and gradually
increase it after having verified that it is functioning cor-
rectly without any noises or vibrations.
DO NOT REACH MAXIMUM PRESSURE UNLESS THE ENTIRE SYSTEM HAS BEEN
FILTERED TO ELIMINATE ANY PARTICLES OF DIRT THAT MAY BE PRESENT.
NOTE:
During running-in stage follow steps below.
3.
Check correct revolution and direction of rotation.
4.
Make sure functioning is regular and without any exces-
sive noises and vibrations.
5.
Make sure oil temperature does not exceed values
listed previously.
Figure 3-16. Drive Hub Identification Plate
Go to
Discount-Equipment.com
to
order your
parts
