![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-1250ajp/jlg-1250ajp_service-and-maintenance-manual_1655741126.webp)
SECTION 3 - CHASSIS & TURNTABLE
3-72
3121171
Hub-Shaft Disassembly
1.
Using retaining ring pliers, remove Retaining Ring (1I)
from groove in Output Shaft (1A) and discard.
EYE PROTECTION SHOULD BE WORN DURING THIS PROCEDURE.
2.
Remove Thrust Washer (1H).
3.
While supporting Housing (1G) on Output Shaft (1A)
end, press Output Shaft (1A) out of Housing (1G).
NOTE:
Lip Seal (1B) may or may not be pressed out of Housing
(1G) by Bearing Cone (1D) during this step.
4.
Remove Bearing Cone (1F) from Housing (1G).
5.
Invert Housing (1G) and remove Lip Seal (1B) if not
already removed when Output Shaft (1A) was pressed
out of Housing (1G).
6.
Remove Bearing Cone (1D).
7.
Bearing Cups (1C & 1E) will remain in Housing (1G).
NOTE:
If bearing replacement is necessary, Bearing Cups (1C & 1E)
can be removed with a slide hammer puller or driven out
with a punch.
1A. Output Shaft
1B. Lip Seal
1C. Tapered Bearing Cup
1D. Tapered Bearing Cone
1E. Tapered Bearing Cup
1F. Tapered Bearing Cone
1G.
Housing
1H. Thrust Washer
1I. Retaining Ring
1J. O-Ring Plug
Figure 3-43. Swing Drive - Hub Shaft Disassembly (SN 0300201017 through 0300254456)
Go to
Discount-Equipment.com
to
order your
parts