Appendix B - 4 - Dual Magnetic Card Reader Install-
ation
F M S P a r t N u m b e r 2 0 - 4 4 4 3 - M A G 2
WARNING:
To prevent an electrical shock hazard, de-energize the Terminal
before you do this procedure! Push the Terminal rocker switch on the Power
Supply to the
O
(Off) position.
This option can be added with a factory-installed card reader or as a secondary back-up card reader with a
primary 20-4443-MAG upgrade installation.
Remove the Blank-out Plate(s)
If a secondary card reader is installed with a factory-installed card reader there will only be one Blank-out
Plate to remove. If a primary (20-4443-MAG) and a secondary (20-4443-MAG2) reader are to be installed
you must remove the two side-by-side Blank-out Plates. The procedure is the same for the two plates.
Doc. No.: M1010 Rev.: 10
Page 61 of 98
Summary of Contents for Petro Vend 200 M1010
