OPW Petro Vend 200 M1010, Installation, Operation And Maintenance Manual

Page: 55 / 98

4. Put the ChipKey unit (20-41147) through the ChipKey plate (51-0450) until it is flush.
5. Push the clip (50-0137) through the slots on both sides of the ChipKey unit so that it holds the unit
tightly.
6. Peel the backing off of the ChipKey label (54-0328) and attach the label to the front surface of the plate.
ChipKey Sub-Assembly Installation
7. Put the Gasket (50-2254) around the ChipKey Plate studs. Put the Sub-assembly with the Gasket
through the open pocket slot until they are flush with the front panel of the pocket.
8. Hold the Sub-assembly and Gasket in place and put the two (2) Mounting Brackets (51-0449) over the
top and bottom pairs of studs as shown above.
9. Put the four (4) KEPS nuts (50-0005) on the Chipkey plate studs and turn them clockwise with a 5/16”
socket or nut driver until they are tight.
Doc. No.: M1010 Rev.: 10
Page 55 of 98