1. Remove the nuts from the blank-out plate screw posts for the applicable pocket slot where the card
reader will be installed.
2. Remove the bracket.
3. Pull out the blank-out plate and gasket.
Do the same for the second plate (if applicable).
Install the Card Reader(s)
NOTE:
If there is a factory-installed Mag Card Reader in one of the pocket slots, disconnect
the 10-Pin cable connector from the J13 connector of the PV200 Main Board. This will be
connected to the 20-0417 Dual Reader PCB after it is installed.
If two readers will be installed they will use the same installation procedure as shown below.
Doc. No.: M1010 Rev.: 10
Page 62 of 98
Summary of Contents for Petro Vend 200 M1010
