Section 10 PV200 Terminal Setup
The PV200 Terminal uses an intuitive user interface for easy setup.
A DIP-Switch block in the top left corner of the controller board is used to open the Terminal Setup screen.
l
Move switch #1 to the
ON
position to gain access to the Terminal Setup Main Menu.
l
Push
Reset
.
IMPORTANT:
The unit will not operate if Switch #1 and Switch #8 are both in the ON position.
Switch #8 is used to put the screen in Test Mode. Make sure all switches are in the OFF
position before you move Switch #1 to open the Terminal Setup screen.
10.1 Screen Controls
Doc. No.: M1010 Rev.: 10
Page 40 of 98
Summary of Contents for Petro Vend 200 M1010
