OPW Petro Vend 200 M1010, Installation, Operation And Maintenance Manual

Page: 35 / 98

To install the 6" antenna to the enclosure for wireless operation:
1. Loosen and remove the hole plug wing-nut and washer from the inside of the enclosure.
2. Remove the hole plug assembly from the knockout on the top of the enclosure.
3. Carefully punch out the knockout.
IMPORTANT: Make sure the knockout is punched out clean and that the top of the enclosure
around the hole does not get bent.
4. Put the bulkhead connector and cable of the antenna assembly through the hole.
NOTE: If the connector does not go through the hole easily, use a file to increase the
dimension of the hole sufficient for clearance. Be sure to clean the filings from the bottom of
the enclosure.
5. Put the washer and nut of the antenna assembly on the threaded bulkhead connector. Turn the nut
clockwise until it is tight.
6. Attach the coaxial cable connector of the antenna to the antenna connector of the wireless bridge
module.
Doc. No.: M1010 Rev.: 10
Page 35 of 98