OPW M2010-EU, Installation Manual

Page: 55 / 149

7.2 Spacer Assembly (6-3/4 RA SS) and Adjustment
IMPORTANT:
The minimum inner diameter for a riser is 52 mm (2.05 in.). This gives an
allowance for the head gaskets so the probe can move freely inside the riser
The DMP Probe can be installed in a minimum 52 mm (2.05 in.) inner diameter riser without modification. If
the probe is to be installed in a riser with an inner diameter up to 4-inches (101.6 mm), a spacer must be
installed. This will keep the probe in the center of the riser and in a vertical position through the bottom of the
tank.
The Probe Spacer kit contains:
l
One (1) stainless steel, flexible spacer.
l
Two (2) M3x8 screws
l
Two (2) M3 nuts
Doc. No.: M2010-EU Rev.: 13
Page 55 of 149