OPW M2010-EU, Installation Manual

Page: 14 / 149

1.7 Precision Leak Test
A third-party Precision Leak Test must be done on each tank and product line (of special importance for older
tanks) before the console is installed. This test will make sure that leak data supplied by the system is
accurate and correct. A pressurized, precision leak-test can be done on a tank after the probe has been
installed (pressure must NOT be more than 5 psi [0.34 bar]).
NOTE:
Most regulatory agencies will accept the ATG tank test for the acceptance test on new
tank installations. Make sure this applies to your local agency before a tank is tested.
1.7.1 Before Initial Inspection
Refer to the initial Site Survey form (
M00-2017- Site Survey
) and compare the equipment that was shipped
to what is recorded in the site survey.
NOTE:
It is not necessary for all site survey questions to be answered. For all unanswered
questions, please respond with “N/A.” Do not leave empty fields!
1.7.2 Initial Inspection
All packed items should be given a full visual inspection for damage that could have occurred during
shipping.
The console Data Sheet found in the product container supplies important information about the tank gauge
system. Keep the Data Sheet and OPW Technical Documentation CD in a safe location.
A Field Wiring Diagram is included in the product container. Give this diagram to your installer or electrician.
The console Data Sheet, Field Wiring Diagram and other documentation related to your SiteSentinel
®
Nano
®
can also be found and downloaded from the OPW global website at
www.opwglobal.com
.
Doc. No.: M2010-EU Rev.: 13
Page 14 of 149