OPW M2010-EU, Installation Manual

Page: 115 / 149

Appendix E - Pro Gauge Probe Installation
The installation instructions in this section are applicable for sites that will use ProGauge XMT-SI-RF probes.
IMPORTANT:
ProGauge probes cannot be connected to the internal I.S. barrier of the OPW-
FMS SiteSentinel NANO. The XMT-SI-RF wireless probe first sends a signal to an RF
Receiver that will then communicate with the NANO through an RS485 serial connection. The
appendices that follow will give all of the necessary information on the installation of these
devices.
General Information
Safety
Read these instructions carefully
The manufacturer is not responsible for any operation not given in these instructions.
Failure or unsatisfactory operation of this equipment must be referred to authorized personnel for
maintenance or, contact the manufacturer directly.
WARNING: To prevent explosion or fire, it is recommended to use non-
sparking tools in an environment that could contain flammable
hydrocarbon vapors. DO NOT USE CORDED ELECTRIC OR
BATTERY OPERATED POWER TOOLS. Only use pneumatic or
manual tools.
NOTICE: The manufacturer is not responsible for injury and/or property damage.
IMPORTANT:
Please refer to
"Installer Safety" on page 13 for important safety information
related to installation of this equipment.
Technical Characteristics
XMT-SI-RF
l
Internal power supply through an instrinsically safe battery 3.6V, 16Ah
l
Low frequency transmission to a receiver located in a safety zone
l
Consumption <15 mA @ 12 Vdc normal function
l
Consumption < 200 uA @12 Vdc in sleep mode
Doc. No.: M2010-EU Rev.: 13
Page 115 of 149