OPW M2010-EU, Installation Manual

Page: 19 / 149

2.3.2 Installation Video
Scan the code below or click the link to see the video, "Installation of an OPW Nano Tank Gauge."
https://www.youtube.com/watch?v=qPZAe5_oWVk&feature=youtu.be
IMPORTANT:
Make sure the electrical wiring is connected on the left side of the console and
the Tank-Probe and Smart-Sensor wiring is connected on the right side.
2.4 Wiring Requirements
CAUTION: Refer to local regulations for all installations. Rigid steel conduit
must be used if possible.
2.4.1 Electrical and I.S. Barrier Wiring
CAUTION: Make sure that the I.S. ground wire and Earth ground are
correctly attached to the console back to the electrical panel. This is to
prevent high-voltages sent to the I.S. wiring side if there is a field short.
NOTICE: Make sure there are no bare wires outside of the block when you connect wires
to the connectors. This is to prevent shorts to the high-voltage on the electrical side and to
prevent damage to the barrier and/or the Tank-Probe from shorts on the I.S. side.
Doc. No.: M2010-EU Rev.: 13
Page 19 of 149