OPW M2010-EU, Installation Manual

Page: 120 / 149

Jumper Setting
Jumper settings are shown below. The Jumpers are read during device startup. When changes are made,
the device must be switched off and restarted for the changes to be applied.
Jumper
#
Inserted Removed
1 1 Float 2 Floats
2 Diagnostic Mode (for production use only) NORMAL Mode (recommended)
3 Wired Probe RF Probe
4
Select Protocol 1 (applicable only for RS485
probe) Select Protocol 2 (applicable only for RS485
probe)
The illustration below shows the location of the Jumper Block on the probe board.
XMT-SI-RF DIP-Switch Settings
The RF probes have a selection of Operation Modes that have an effect on battery life. The internal DIP-
Switch block is used to configure the Operation Mode.
NOTE:
RF probes use a frequency of 169,4 Mhz, transmit on channel 5 (169,468 MHz),
power 80 mW (standard) up to 200 mW.
The illustration below shows the location of the DIP-Switch Block on the probe board.
Doc. No.: M2010-EU Rev.: 13
Page 120 of 149