OPW M2010-EU, Installation Manual

Page: 94 / 149

Specifications
Operating Temperature: -40°C to +70°C (-40°F to 158°F)
D-10 Dimensions:
D-20 Dimensions: Diameter: 5.8 cm (2.3 in.), Length: 28.2 cm (11.1 in.)
Diameter: 5.8 cm (2.3 in.), Length: 53.6 cm (21.1 in.)
Float Requirements: Low: 3.8 cm (1.5 in.), High: 27.9 cm (11 in.)
Cable:
Belden #88760 or Alpha #55371
3.6m (12 feet) of gas & oil resistant cable to the inline ISIM
+ 1.3m (4 feet) ISIM tail.
Maximum Wiring Length*: 305 m (1,000 ft.) field wiring
Alarm Threshold Configuration: Fully Automatic
Diagnostic Reading on sensor setup:
12 to 13 (normal),
3 to 4 (lower float in alarm - raised),
1 to 2 (upper and lower float in alarm - raised)
Multi-Drop Restriction
See Mixed Multi-Drop Installation
Connections: Red = Power, Black = Signal, Shield = Ground
NOTE:
*This is the maximum length of wire to be used to connect all sensors on one channel.
This length includes the wire from the VSmart to each sensor board in the string.
Installation
IMPORTANT: This Smart Sensor must ONLY be connected to an OPW Fuel Management
Systems 12V VSmart Module. This will make sure that operation conditions are safe. Smart
Sensors CANNOT be used with SS1, 2 or 3, iTouch or EECO consoles.
Doc. No.: M2010-EU Rev.: 13
Page 94 of 149