OPW M2010-EU, Installation Manual

Page: 121 / 149

DIP-Switch settings are shown below. The DIP-Switches are read during device startup. When changes are
made, the device must be switched off and restarted for the changes to be applied.
To optimize battery life, the probe usually operates in Sleep Mode.
The probe will be started at the time increment set by the selected Operation Mode and will make its
measurement. If the product or water level measurement is ±1 mm compared to the last measurement, the
probe will transmit the measurement. If the measurement comparison is less than 1 mm, the probe will return
to Sleep Mode.
NOTE: To prevent a time-out of the system, the probe will always transmit data after 10
minutes of non-transmission.
The probe is not supplied with the battery because the lithium battery is a Class 9 Hazmat. The battery must
be purchased separately. Before the probe is installed, open the probe housing to connect the battery. More
information on the battery can be found in the section
"Important Battery Information" on page 124
below.
If the Operation Mode is set between 1 - 5, the probe will transmit data after power-up every five (5) seconds
for the first 24 hours. After that period, the probe will begin to transmit at the selected Operation Mode.
Doc. No.: M2010-EU Rev.: 13
Page 121 of 149