OPW M2010-EU, Installation Manual

Page: 17 / 149

2.3 Console Installation
2.3.1 Installation Instructions
1. Select an area to install the SiteSentinel® Nano® console on a wall in a safe indoor location. The
display must be at approximately eye level and easily seen.
a. Make sure there is sufficient access to the communication ports on the bottom of the console.
b. Make sure to keep sufficient clearance below or above the unit to install power and
communication conduits to the console.
2. Remove the two (2) screws on the two sides of the console that hold the cover in position. Keep them in
a safe area to be used again below in
"Complete the Installation" on page 23
.
3. Put a small screwdriver into one of the two (2) release holes on the left side of the console. Push the
screwdriver in until you feel the cover release. Do the same with the second release hole. Set the cover
aside.
4. Hold the unit against the wall where it will be installed. There are three (3) screw holes in the unit. Use
a pen to make a mark to show the screw hole locations on the wall.
5. Drill the holes at the pen marks. Tap the hole with the correct size screw threads or put screw anchors
in the hole.
Doc. No.: M2010-EU Rev.: 13
Page 17 of 149